Turning sound into energy
p2pnet.net news:- Heat into sound, into electricity. That’s the claim of University of Utah physics professor Orest Symko: a new source of renewable energy from waste heat.
Five of his doctoral students (see below) built prototypes of acoustic heat-engine devices and they plan to present their findings on June 8 during the annual meeting of the Acoustical Society of America at the Hilton Salt Lake City Center hotel.
“Symko plans to test the devices within a year to produce electricity from waste heat at a military radar facility and at the university’s hot-water-generating plant,” says the university, pointing out the research is funded by the US. Army.
It’s interest? “Taking care of waste heat from radar, and also producing a portable source of electrical energy which you can use in the battlefield to run electronics” says Symko, who hopes the devices will be used within two years as an alternative to photovoltaic cells for converting sunlight into electricity.
Symko works with collaborators at Washington State University and the University of Mississippi and the project has received $2 million in funding during the past two years.
He hopes it’ll grow as small heat-sound-electricity devices shrink further so they can be incorporated in micromachines (known as microelectromechanical systems, or MEMS) for use in cooling computers and other electronic devices such as amplifiers.
- Bonnie McLaughlin showed it was possible to double the efficiency of converting heat into sound by optimizing the geometry and insulation of the acoustic resonator and by injecting heat directly into the hot heat exchanger. She built cylindrical devices 1.5 inches long and a half-inch wide, and worked to improve how much heat was converted to sound rather than escaping. As little as a 90-degree Fahrenheit temperature difference between hot and cold heat exchangers produced sound. Some devices produced sound at 135 decibels – as loud as a jackhammer.
- Nick Webb showed that by pressurizing the air in a similar-sized resonator, it was able to produce more sound, and thus more electricity. He also showed that by increasing air pressure, a smaller temperature difference between heat exchangers is needed for heat to begin converting into sound. That makes it practical to use the acoustic devices to cool laptop computers and other electronics that emit relatively small amounts of waste heat, Symko says.
Numerous heat-to-sound-to-electricity devices will be needed to harness solar power or to cool large, industrial sources of waste heat. - Brenna Gillman learned how to get the devices – mounted together to form an array – to work together. For an array to efficiently convert heat to sound and electricity, its individual devices must be “coupled” to produce the same frequency of sound and vibrate in sync. Gillman used various metals to build supports to hold five of the devices at once. She found the devices could be synchronized if a support was made of a less dense metal such as aluminum and, more important, if the ratio of the support’s weight to the array’s total weight fell within a specific range. The devices could be synchronized even better if they were “coupled” when their sound waves interacted in an air cavity in the support.
- Ivan Rodriguez used a different approach in building an acoustic device to convert heat to electricity. Instead of a cylinder, he built a resonator from a quarter-inch-diameter hollow steel tube bent to form a ring about 1.3 inches across. In cylinder-shaped resonators, sound waves bounce against the ends of the cylinder. But when heat is applied to Rodriguez’s ring-shaped resonator, sound waves keep circling through the device with nothing to reflect them. Symko says the ring-shaped device is twice as efficient as cylindrical devices in converting heat into sound and electricity. That is because the pressure and speed of air in the ring-shaped device are always in sync, unlike in cylinder-shaped devices.
- Myra Flitcroft designed a cylinder-shaped heat engine one-third the size of the other devices. It is less than half as wide as a penny, producing a much higher pitch than the other resonators. When heated, the device generated sound at 120 decibels – the level produced by a siren or a rock concert. “It’s an extremely small thermoacoustic device – one of the smallest built – and it opens the way for producing them in an array,” Symko says.
Also See:
University of Utah – A Sound Way to Turn Heat into Electricity, June 4, 2007
If your Net access is blocked by government restrictions, try Psiphon from the Citizen Lab at the University of Toronto’s Munk Centre for International Studies. Go here for the official download, and here for details. And if you’re Chinese and you’re looking for a way to access independent Internet news sources, try Freegate, the DIT program written to help Chinese citizens circumvent web site blocking outside of China. Download it here.
rss feed: http://p2pnet.net/p2p.rss | | Mobile – http://p2pnet.net/index-wml.php | | And use free p2pnet newsfeeds for your site
Tired of being treated like a criminal? They depend on you, not the other way around. Don’t buy their ‘product’. Do bug your local politicians. Use emails, snail-mail, phone calls, faxes, IM, stop them in the street, blog. And if you’re into organizing, organize petitions, organize demonstrations and then turn up on your local political rep’s doorstep, making sure you’ve contacted your local tv/radio station/newspaper in advance. Don’t just complain. Do something!
